Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 181
no set mld, Interface Interface Config Mode. This command also enables MLD Snooping on a particular
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 181 highlights
ProSafe Managed Switch set mld Use this command to enable MLD Snooping on the system (Global Config Mode) or an Interface (Interface Config Mode). This command also enables MLD Snooping on a particular VLAN and enables MLD Snooping on all interfaces participating in a VLAN. If an interface has MLD Snooping enabled and you enable this interface for routing or enlist it as a member of a port-channel (LAG), MLD Snooping functionality is disabled on that interface. MLD Snooping functionality is re-enabled if you disable routing or remove port channel (LAG) membership from an interface that has MLD Snooping enabled. MLD Snooping supports the following activities: • Validation of address version, payload length consistencies and discarding of the frame upon error. • Maintenance of the forwarding table entries based on the MAC address versus the IPv6 address. • Flooding of unregistered multicast data packets to all ports in the VLAN. Default Format Mode disabled set mld vlanid • Global Config • Interface Config • VLAN Mode no set mld Use this command to disable MLD Snooping on the system. Format Mode set mld vlanid • Global Config • Interface Config • VLAN Mode set mld interfacemode Use this command to enable MLD Snooping on all interfaces. If an interface has MLD Snooping enabled and you enable this interface for routing or enlist it as a member of a port-channel (LAG), MLD Snooping functionality is disabled on that interface. MLD Snooping functionality is re-enabled if you disable routing or remove port-channel (LAG) membership from an interface that has MLD Snooping enabled. Default Format Mode disabled set mld interfacemode Global Config Switching Commands 181