Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 413
maximum-paths OSPFv3, passive-interface default OSPFv3, no maximum-paths
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 413 highlights
ProSafe Managed Switch maximum-paths (OSPFv3) This command sets the number of paths that OSPF can report for a given destination where maxpaths is platform dependent. Default Format Mode 4 maximum-paths Router OSPFv3 Config no maximum-paths This command resets the number of paths that OSPF can report for a given destination back to its default value. Format Mode no maximum-paths Router OSPFv3 Config passive-interface default (OSPFv3) Use this command to enable global passive mode by default for all interfaces. It overrides any interface level passive mode. OSPF shall not form adjacencies over a passive interface. Default Format Mode disabled passive-interface default Router OSPFv3 Config no passive-interface default(OSPFv3) Use this command to disable the global passive mode by default for all interfaces. Any interface previously configured to be passive reverts to non-passive mode. Format Mode no passive-interface default Router OSPFv3 Config passive-interface (OSPFv3) Use this command to set the interface or tunnel as passive. It overrides the global passive mode that is currently effective on the interface or tunnel. Default Format Mode disabled passive-interface { | tunnel } Router OSPFv3 Config IPv6 Commands 413