Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 476
match ip tos, match protocol
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 476 highlights
ProSafe Managed Switch Default Format Mode none match ip precedence Class-Map Config match ip tos This command adds to the specified class definition a match condition based on the value of the IP TOS field in a packet, which is defined as all eight bits of the Service Type octet in the IP header. The value of is a two-digit hexadecimal number from 00 to ff. The value of is a two-digit hexadecimal number from 00 to ff. The denotes the bit positions in that are used for comparison against the IP TOS field in a packet. For example, to check for an IP TOS value having bits 7 and 5 set and bit 1 clear, where bit 7 is most significant, use a value of a0 (hex) and a of a2 (hex). Note: The IP DSCP, IP Precedence, and IP ToS match conditions are alternative ways to specify a match criterion for the same Service Type field in the IP header, but with a slightly different user notation. Note: This "free form" version of the IP DSCP/Precedence/TOS match specification gives the user complete control when specifying which bits of the IP Service Type field are checked. Default Format Mode none match ip tos Class-Map Config match protocol This command adds to the specified class definition a match condition based on the value of the IP Protocol field in a packet using a single keyword notation or a numeric value notation. To specify the match condition using a single keyword notation, the value for is one of the supported protocol name keywords. The currently supported values are: icmp, igmp, ip, tcp, udp. A value of ip matches all protocol number values. To specify the match condition using a numeric value notation, the protocol number is a standard value assigned by IANA and is interpreted as an integer from 0 to 255. Quality of Service (QoS) Commands 476