Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 503

ProSafe Managed Switch no ipv6 access-list This command deletes the IPv6 ACL identified by from the system. Format Mode no ipv6 access-list Global Config ipv6 access-list rename This command changes the name of an IPv6 ACL. The parameter is the name of an existing IPv6 ACL. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IPv6 access list. This command fails is an IPv6 ACL by the name already exists. Format Mode ipv6 access-list rename Global Config {deny | permit} (IPv6) This command creates a new rule for the current IPv6 access list. Each rule is appended to the list of configured rules for the list. Note: The 'no' form of this command is not supported, since the rules within an IPv6 ACL cannot be deleted individually. Rather, the entire IPv6 ACL must be deleted and respecified. Note: An implicit 'deny all' IPv6 rule always terminates the access list. A rule may either deny or permit traffic according to the specified classification fields. At a minimum, either the 'every' keyword or the protocol, source address, and destination address values must be specified. The source and destination IPv6 address fields may be specified using the keyword 'any' to indicate a match on any value in that field. The remaining command parameters are all optional, but the most frequently used parameters appear in the same relative order as shown in the command format. The assign-queue parameter allows specification of a particular hardware queue for handling traffic that matches this rule. The allowed value is 0-(n-1), where n is the number of user configurable queues available for the hardware platform. The assign-queue parameter is valid only for a permit rule. The mirror parameter allows the traffic matching this rule to be copied to the specified , while the redirect parameter allows the traffic matching this rule to be Quality of Service (QoS) Commands 503