Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 497
parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 497 highlights
ProSafe Managed Switch Parameter [precedence | tos | dscp ] [log] rate-limit [assign-queue ] [{mirror | redirect} ] Description Specifies the TOS for an IP ACL rule depending on a match of precedence or DSCP values using the parameters dscp, precedence, tos/tosmask. Specifies that this rule is to be logged. The user can specify a simple rate limiter for packets matching an ACL "permit" rule. The user needs to specify the burst size in kbytes and allowed rate of traffic in kbps. The conforming traffic is allowed to transmit, and non-conforming traffic is dropped. This action is ignored for any "deny" rule, since by definition matching packets are dropped. Specifies the assign-queue, which is the queue identifier to which packets matching this rule are assigned. Specifies the mirror or redirect interface which is the unit/slot/port to which packets matching this rule are copied or forwarded, respectively. no access-list This command deletes an IP ACL that is identified by the parameter from the system. The range for 1-99 for standard access lists and 100-199 for extended access lists. Format Mode no access-list Global Config ip access-list This command creates an extended IP Access Control List (ACL) identified by , consisting of classification fields defined for the IP header of an IPv4 frame. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IP access list. If an IP ACL by this name already exists, this command enters IPv4-Access_List config mode to allow updating the existing IP ACL. Note: The CLI mode changes to IPv4-Access-List Config mode when you successfully execute this command. Format Mode ip access-list Global Config Quality of Service (QoS) Commands 497