Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 168
set igmp groupmembership-interval, no set igmp fast-leave
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 168 highlights
ProSafe Managed Switch LAN interface from its forwarding table entry upon receiving an IGMP leave message for that multicast group without first sending out MAC-based general queries to the interface. You should enable fast-leave admin mode only on VLANs where only one host is connected to each layer 2 LAN port. This prevents the inadvertent dropping of the other hosts that were connected to the same layer 2 LAN port but were still interested in receiving multicast traffic directed to that group. Also, fast-leave processing is supported only with IGMP version 2 hosts. Default Format Mode disabled set igmp fast-leave Interface Config Format Mode set igmp fast-leave VLAN Config no set igmp fast-leave This command disables IGMP Snooping fast-leave admin mode on a selected interface. Format Mode no set igmp fast-leave Interface Config Format Mode no set igmp fast-leave VLAN Config set igmp groupmembership-interval This command sets the IGMP Group Membership Interval time on a VLAN, one interface or all interfaces. The Group Membership Interval time is the amount of time in seconds that a switch waits for a report from a particular group on a particular interface before deleting the interface from the entry. This value must be greater than the IGMPv3 Maximum Response time value. The range is 2 to 3600 seconds. Default Format Mode 260 seconds set igmp groupmembership-interval • Interface Config • Global Config Format Mode set igmp groupmembership-interval VLAN Config Switching Commands 168