Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 304
trapflags OSPF, group name
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 304 highlights
ProSafe Managed Switch Format Mode timers spf Router OSPF Config trapflags (OSPF) Use this command to enable individual OSPF traps, enable a group of trap flags at a time, or enable all the trap flags at a time. The different groups of trapflags, and each group's specific trapflags to enable or disable, are listed in Table 1. Table 1. Trapflags Groups Group errors if-rx lsa overflow retransmit rtb state-change Flags • authentication-failure • bad-packet • config-error • virt-authentication-failure • virt-bad-packet • virt-config-error ir-rx-packet • lsa-maxage • lsa-originate • lsdb-overflow • lsdb-approaching-overflow • packets • virt-packets • rtb-entry-info • if-state-change • neighbor-state-change • virtif-state-change • virtneighbor-state-change • To enable the individual flag, enter the group name followed by that particular flag. • To enable all the flags in that group, give the group name followed by all. • To enable all the flags, give the command as trapflags all. Routing Commands 304