Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 195

ProSafe Managed Switch lldp receive Use this command to enable the LLDP receive capability. Default Format Mode enabled lldp receive Interface Config no lldp receive Use this command to return the reception of LLDPDUs to the default value. Format Mode no lldp receive Interface Config lldp timers Use this command to set the timing parameters for local data transmission on ports enabled for LLDP. The determines the number of seconds to wait between transmitting local data LLDPDUs. The range is 1-32768 seconds. The is the multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The multiplier range is 2-10. The is the delay before re-initialization, and the range is 1-0 seconds. Default Format Mode • interval-30 seconds • hold-4 • reinit-2 seconds lldp timers [interval ] [hold ] [reinit ] Global Config no lldp timers Use this command to return any or all timing parameters for local data transmission on ports enabled for LLDP to the default values. Format Mode no lldp timers [interval] [hold] [reinit] Global Config lldp transmit-tlv Use this command to specify which optional type length values (TLVs) in the 802.1AB basic management set are transmitted in the LLDPDUs. Use sys-name to transmit the system name TLV. To configure the system name, see snmp-server on page 683. Use sys-descto transmit the system description TLV. Use sys-cap to transmit the system capabilities TLV. Switching Commands 195