Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 192

ProSafe Managed Switch no port-security max-static This command sets maximum number of statically locked MAC addresses to the default value. Format Mode no port-security max-static Interface Config port-security mac-address This command adds a MAC address to the list of statically locked MAC addresses. The is the VLAN ID. Format Mode port-security mac-address Interface Config no port-security mac-address This command removes a MAC address from the list of statically locked MAC addresses. Format Mode no port-security mac-address Interface Config port-security mac-address move This command converts dynamically locked MAC addresses to statically locked addresses. Format Mode port-security mac-address move Interface Config port-security mac-address sticky This command enables sticky mode Port MAC Locking on a port. If accompanied by a MAC address and a VLAN id (for interface config mode only), it adds a sticky MAC address to the list of statically locked MAC addresses. These sticky addresses are converted back to dynamically locked addresses if sticky mode is disabled on the port. The is the VLAN ID. The Global command applies the sticky mode to all valid interfaces (physical and LAG). There is no global sticky mode as such. Sticky addresses that are dynamically learned will appear in show running config as port-security mac-address sticky entries. This distinguishes them from static entries. Format Modes port-security mac-address sticky [ ] • Global Config • Interface Config Switching Commands 192