Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 484

ProSafe Managed Switch Format Mode policy-map [in|out] Global Config no policy-map This command eliminates an existing DiffServ policy. The parameter is the name of an existing DiffServ policy. This command may be issued at any time. If the policy is currently referenced by one or more interface service attachments, this delete attempt fails. Format Mode no policy-map Global Config policy-map rename This command changes the name of a DiffServ policy. The is the name of an existing DiffServ class. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the policy. Format Mode policy-map rename Global Config DiffServ Service Commands Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which you specified by using the policy commands, to an interface in the incoming direction The service commands attach a defined policy to a directional interface. You can assign only one policy at any one time to an interface in the inbound direction. DiffServ is not used in the outbound direction. This set of commands consists of service addition/removal. The CLI command root is service-policy. service-policy This command attaches a policy to an interface in the inbound direction. The parameter is the name of an existing DiffServ policy. This command causes a service to create a reference to the policy. Note: This command effectively enables DiffServ on an interface in the inbound direction. There is no separate interface administrative 'mode' command for DiffServ. Quality of Service (QoS) Commands 484