Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 14

ProSafe Managed Switch • Quality of Service • Management (CLI, Web UI, and SNMP) • IPv6 Management-Allows management of the device through an IPv6 through an IPv6 address without requiring the IPv6 Routing package in the system. The management address can be associated with the network port (front-panel switch ports) and a routine interface (port or VLAN). • Stacking Not all modules are available for all platforms or software releases. Command Modes The CLI groups commands into modes according to the command function. Each of the command modes supports specific software commands. The commands in one mode are not available until you switch to that particular mode, with the exception of the User EXEC mode commands. You can execute the User EXEC mode commands in the Privileged EXEC mode. The command prompt changes in each command mode to help you identify the current mode. Table 5 describes the command modes and the prompts visible in that mode. Note: The command modes available on your switch depend on the software modules that are installed. For example, a switch that does not support BGPv4 does not have the Router BGPv4 Command Mode. Table 5. CLI Command Modes Command Mode Prompt User EXEC Switch> Privileged EXEC Switch# Global Config Switch (Config)# VLAN Config Switch (Vlan)# Mode Description Contains a limited set of commands to view basic system information. Allows you to issue any EXEC command, enter the VLAN mode, or enter the Global Configuration mode. Groups general setup commands and permits you to make modifications to the running configuration. Groups all the VLAN commands. Using the Command-Line Interface 14