Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 528
show poe pd
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 528 highlights
ProSafe Managed Switch Intf Power 1/0/33 No Power (W) ----18.0 Class ------2 Power Current (W) (mA) 04.400 84 Voltage (volt) ------53.3 Status Delivering Power Fault Status No Error show poe pd Use this command to get information about the PD ports. You can display information based on each individual port or all the PD ports collectively. Note: Only the GSM5212P supports this command. Format Mode show poe pd [ | all] Privileged EXEC User EXEC Term Intf Mode Class Detection Mode Status Definition Show the PD device interface number, only 0/1 or 0/2 on the GSM5212P. In other devices, the table is empty. If is not specified, all PD ports are displayed. Displays the port POE role and is always PD. Displays the POE class. PD detection mode when getting power from the PSE: • 1-event-PSE detects the PD in 1-event mode (802.1f) • 2-event-PSE detects the PD in 2-event mode (802.1at) • LLDP-PSE detects the PD in LLDP mode (802.1at) Shows whether the port 0/1 or 0/2 is providing power: • Powered-Receiving power from PSE • Off-No power from the PSE (when main AC is in used) Example: (switch) #show poe pd all Intf ---0/1 0/2 Mode ----PD PD Class --------class 4 class 4 Detection Mode 2-event LLDP Status ---------- powered powered Power over Ethernet (PoE) Commands 528