Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 279
ip helper enable, ip helper-address, no ip helper-address Global Config
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 279 highlights
ProSafe Managed Switch udp-port-list: The broadcast packet destination UDP port number to forward. If not specified, packets for the default services are forwarded to the helper address. Valid range, 0-65535. Default Format Mode Disabled ip helper-address {|dhcp|domain|isakmp|mobile-ip|nameserver| netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time} Global Config no ip helper-address (Global Config) Use this command to remove the IP address from the previously configured list. The no command without an argument removes the entire list of helper addresses on that interface. Format Mode no ip helper-address {} {|dhcp|domain|isakmp|mobile-ip|nameserver| netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time} GlobalConfig ip helper enable Use this command to enable relay of UDP packets. This command can be used to temporarily disable IP helper without deleting all IP helper addresses. This command replaces the bootpdhcprelay enable command, but affects not only relay of DHCP packets, but also relay of any other protocols for which an IP helper address has been configured. Default Format Mode disabled ip helper enable Global Config no ip helper enable Use this command to disable relay of all UDP packets. Format Mode no ip helper enable Global Config ip helper-address Use this command to add a unicast helper address to the list of helper addresses on an interface. This is the address of a DHCP server. This command can be applied multiple times Routing Commands 279