Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 584

ProSafe Managed Switch One IP address is required, although one can specify up to eight addresses in one command line. Servers are listed in order of preference (address1 is the most preferred server, address2 is the next most preferred server, and so on). Default Format Mode none netbios-name-server [...] DHCP Pool Config no netbios-name-server This command removes the NetBIOS name server list. Format Mode no netbios-name-server DHCP Pool Config netbios-node-type The command configures the NetBIOS node type for Microsoft Dynamic Host Configuration Protocol (DHCP) clients. type specifies the NetBIOS node type. Valid types are: • b-node-Broadcast • p-node-Peer-to-peer • m-node-Mixed • h-node-Hybrid (recommended) Default Format Mode none netbios-node-type DHCP Pool Config no netbios-node-type This command removes the NetBIOS node Type. Format Mode no netbios-node-type DHCP Pool Config next-server This command configures the next server in the boot process of a DHCP client.The parameter is the IP address of the next server in the boot process, which is typically a TFTP server. Default inbound interface helper addresses Utility Commands 584