Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 697

ProSafe Managed Switch address or dns name of the previously configured RADIUS authentication / accounting server. Format Mode no radius server host {auth | acct} {} Global Config The following shows an example of the command. (Switch) (Config) #radius server host acct 192.168.37.60 (Switch) (Config) #radius server host acct 192.168.37.60 port 1813 (Switch) (Config) #radius server host auth 192.168.37.60 name Network1_RADIUS_Auth_Server port 1813 (Switch) (Config) #radius server host acct 192.168.37.60 name Network2_RADIUS_Auth_Server (Switch) (Config) #no radius server host acct 192.168.37.60 radius server key Use this command to configure the key to be used in RADIUS client communication with the specified server. Depending on whether the 'auth' or 'acct' token is used, the shared secret is configured for the RADIUS authentication or RADIUS accounting server. The IP address or hostname provided must match a previously configured server. When this command is executed, the secret is prompted. Text-based configuration supports Radius server's secrets in encrypted and non-encrypted format. When you save the configuration, these secret keys are stored in encrypted format only. If you want to enter the key in encrypted format, enter the key along with the encrypted keyword. In the show running config command's display, these secret keys are displayed in encrypted format. You cannot show these keys in plain text format. Note: The secret must be an alphanumeric value not exceeding 16 characters. Format Mode radius server key {auth | acct} {} encrypted Global Config Field ipaddr dnsname password Description The IP address of the server. The DNS name of the server. The password in encrypted format. Management Commands 697