Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 564

ProSafe Managed Switch Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18 traceroute ipv6 Use the traceroute command to discover the routes that packets actually take when traveling to their destination through the network on a hop-by-hop basis. The parameter must be a valid IPv6 address or hostname. The optional parameter is the UDP port used as the destination of packets sent as part of the traceroute. This port should be an unused port on the destination system. The range for is zero (0) to 65535. The default value is 33434. Default Format Mode port: 33434 traceroute ipv6 [port ] Privileged EXEC clear config This command resets the configuration to the factory defaults without powering off the switch. When you issue this command, a prompt appears to confirm that the reset should proceed. When you enter y, you automatically reset the current configuration on the switch to the default values. It does not reset the switch. Format Mode clear config Privileged EXEC clear eventlog This command clears all event messages maintained in the switch. Format Mode clear eventlog Privileged EXEC clear mac-addr-table This command clears the dynamically learned MAC addresses of the switch. Format Mode clear mac-addr-table Privileged EXEC clear logging buffered This command clears the messages maintained in the system log. Format Mode clear logging buffered Privileged EXEC Utility Commands 564