Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 444

ProSafe Managed Switch show ipv6 pim neighbor Use this command to display the PIM neighbor information for all interfaces or for the specified interface. Format Modes show ipv6 pim neighbor [|vlan] • Privileged EXEC • User EXEC Term Interface Neighbor Address Up Time Expiry Time DR Priority Definition Valid slot and port number separated by forward slashes. The IP address of the neighbor on an interface. The time since this neighbor has become active on this interface. The expiry time of the neighbor on this interface. DR Priority configured on this interface (PM-SM only). Example: The following shows example CLI display output for the command. (Switch) #show ipv6 pim neighbor 0/1 Interface Neighbor Address Up Time (hh:mm:ss) Expiry Time (hh:mm:ss) show ipv6 pim interface Use this command to display PIM configuration information for all interfaces or for the specified interface. If no interface is specified, configuration of all interfaces is displayed. Format Modes show ipv6 pim interface [|vlan] • Privileged EXEC • User EXEC Term Definition Mode Active PIM protocol. Interface Interface number. Hello Interval Hello interval value. The frequency at which PIM hello messages are transmitted on this interface. By default, the value is 30 seconds. Join-prune Interval Join-prune interval value. DR Priority DR priority configured on this interface. This is not applicable if the interface mode is Dense. BSR Border Indicates whether the interface is configured as a BSR border. IPv6 Multicast Commands 444