Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 266

ProSafe Managed Switch show ip irdp This command displays the router discovery information for all interfaces, or a specified interface. Format Modes show ip irdp { | all} • Privileged EXEC • User EXEC Term Interface Ad Mode Advertise Address Max Int Min Int Hold Time Preference Definition The that matches the rest of the information in the row. The advertise mode, which indicates whether router discovery is enabled or disabled on this interface. The IP address to which the interface sends the advertisement. The maximum advertise interval, which is the maximum time, in seconds, allowed between sending router advertisements from the interface. The minimum advertise interval, which is the minimum time, in seconds, allowed between sending router advertisements from the interface. The amount of time, in seconds, that a system should keep the router advertisement before discarding it. The preference of the address as a default router address, relative to other router addresses on the same subnet. Virtual LAN Routing Commands This section describes the commands you use to view and configure VLAN routing and to view VLAN routing status information. vlan routing This command enables routing on a VLAN. The vlanid value has a range from 1 to 4093. The [interface ID] value has a range from 1 to 128. Typically, you will not supply the interface ID argument, and the system automatically selects the interface ID. However, if you specify an interface ID that is already in use, the CLI displays an error message and does not create the VLAN interface. Format Mode vlan routing [interface ID] VLAN Config Routing Commands 266