Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 387
If an IPv6 prefix is con d on the interface, the following information also appears.
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 387 highlights
ProSafe Managed Switch Term Router Advertisement Interval Router Advertisement Managed Config Flag Router Advertisement Other Config Flag Router Advertisement Suppress Flag IPv6 Destination Unreachables Definition The frequency, in seconds, that router advertisements are sent. Shows whether the managed configuration flag is set (enabled) for router advertisements on this interface. Shows whether the other configuration flag is set (enabled) for router advertisements on this interface. Shows whether router advertisements are suppressed (enabled) or sent (disabled). Shows whether ICMPv6 Destination Unreachable messages may be sent (enabled) or not (disabled). For more information, see ipv6 nd router-preference on page 383. Example: The following shows example CLI display output for the command. (Switch) #show ipv6 interface 1/0/1 Routing Mode Disabled Administrative Mode Enabled IPv6 Routing Operational Mode Disabled Bandwidth 100000 kbps Interface Maximum Transmit Unit 1500 Router Duplicate Address Detection Transmits... 1 Router Advertisement NS Interval 0 Router Advertisement Lifetime 1800 Router Advertisement Reachable Time 0 Router Advertisement Interval 600 Router Advertisement Managed Config Flag....... Disabled Router Advertisement Other Config Flag......... Disabled Router Advertisement Suppress Flag Disabled IPv6 Destination Unreachables Enabled No IPv6 prefixes configured. If an IPv6 prefix is configured on the interface, the following information also appears. Term IFPv6 Prefix is Preferred Lifetime Valid Lifetime Onlink Flag Autonomous Flag Definition The IPv6 prefix for the specified interface. The amount of time the advertised prefix is a preferred prefix. The amount of time the advertised prefix is valid. Shows whether the onlink flag is set (enabled) in the prefix. Shows whether the autonomous address-configuration flag (autoconfig) is set (enabled) in the prefix. IPv6 Commands 387