Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 474
match destination-address mac, match dstip, match dstl4port, <ipaddr>, <ipmask>
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 474 highlights
ProSafe Managed Switch match destination-address mac This command adds to the specified class definition a match condition based on the destination MAC address of a packet. The parameter is any layer 2 MAC address formatted as six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The parameter is a layer 2 MAC address bit mask, which need not be contiguous, and is formatted as six, two-digit hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc). Default Format Mode none match destination-address mac Class-Map Config Ipv6-Class-Map Config match dstip This command adds to the specified class definition a match condition based on the destination IP address of a packet. The parameter specifies an IP address. The parameter specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits. Default Format Mode none match dstip Class-Map Config match dstip6 This command adds to the specified class definition a match condition based on the destination IPv6 address of a packet. Default Format Mode none match dstip6 Ipv6-Class-Map Config match dstl4port This command adds to the specified class definition a match condition based on the destination layer 4 port of a packet using a single keyword or numeric notation. To specify the match condition as a single keyword, the value for is one of the supported port name keywords. The currently supported values are: domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www. Each of these translates into its equivalent port number. Quality of Service (QoS) Commands 474