Yamaha DM2000 Owner's Manual - Page 189

Punching In & Out Individual Parameters 175 Punching In & Out Individual Parameters During Automix rerecording, channels can be punched in and out by pressing the channel strip [AUTO] buttons. Individual parameters can be punched in and out as follows. Parameter Channel OVER WRITE Operation Punch In Punch Out Channel Levels (faders) Pan Surround Pan EQ (F, Q, G) EQ On/Off Input Bus Out, Aux Send, Matrix Send Stereo Out FADER Input PAN Input SURR All channels EQ Aux send 1-12 levels Input AUX Aux send 1-12 mutes Input AUX ON Matrix send 1-4 levels Bus Out, Aux Send, Stereo Out AUX Matrix send 1-4 mutes Bus Out, Aux Send, AUX Stereo Out ON Effect parameters Effects processors (certain parameters) 1-8 - User Defined Plug-Ins (parameters 1-4) Plug-Ins 1-8 - Set Layer to input, Fader mode to Fader Set Layer to Master, Fader mode to fader Stereo Out fader Set Layer to input, Encoder mode to Pan (Also use SELECTED CHANNEL section PAN control, or Joystick if [LINK] is on) Select Input Layer and assign Surround LFE Level or Surround Pan Wheel to the Encoders Turn on Auto EQ Edit In preference (see page 237). Use SELECTED CHANNEL EQUALIZER section (If EQ parameter assigned to an Encoder, also use Encoders) Set Layer to input, Fader mode to Aux/Mtrx Set Layer to input, Encoder mode to Aux/Mtrx (Or use SELECTED CHANNEL AUX/MATRIX SEND LEVEL controls) Set Layer to input Set Layer to Master, Fader mode to Aux/Mtrx3 Set Layer to Master, Encoder mode to Aux/Mtrx (Also use SELECTED CHANNEL AUX/MATRIX SEND LEVEL controls) Set Layer to master Touch fader knob and adjust1 Press Encoder and adjust Press Encoder and adjust Adjust control Press EQ [ON] button Touch fader knob and adjust1 Press Encoder and adjust Press SELECTED CHANNEL AUX/MATRIX SEND [ON] button Touch fader knob and adjust1 Press Encoder and adjust Press SELECTED CHANNEL AUX/MATRIX SEND [ON] button Release fader knob2 Press Encoder Press Encoder Press [AUTO] button Press [AUTO] button Release fader knob2 Press Encoder Press [AUTO] button Release fader knob2 Press Encoder Press [AUTO] button Select internal effects processors Push Parame- Push Parameter 1-4 control ter 1-4 control Select Plug-Ins Push Parame- Push Parameter 1-4 control ter 1-4 control User Defined Remote Layers Faders Encoders FADER PAN Select User Defined Remote Layer Select User Defined Remote Layer Touch fader knob and adjust1 Press Encoder and adjust Release fader knob2 Press Encoder 1. TOUCH SENSE IN on Fader Edit page must be on. 2. TOUCH SENSE OUT on Fader Edit page must be on. 3. Cannot be used to control Stereo Out to Matrix Send levels. DM2000-Owner's Manual