Yamaha DM2000 Owner's Manual - Page 238
Setting the Locate Memories, Preroll, Postroll & Rollback, ROLL BACK] button, REHEARSAL] button
View all Yamaha DM2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 238 highlights
224 Chapter 20-Remote Control • When the [QUICK PUNCH] button indicator is lit, pressing the [PLAY] button will locate to the pre-roll point and start playback. At the post-roll point, the machine will stop playback, locate the pre-roll point, and then stop. • When the [QUICK PUNCH] button indicator is lit, pressing the [PLAY] and [REC] buttons together will locate to the pre-roll point and start playback. At the in point, the machine switches to input monitor and starts recording. At the out point, the machine switches to playback monitor and stops recording. At the post-roll point, the machine locates the pre-roll point and then stops. If the [REHEARSAL] button indicator is lit, the machine goes into Record-Rehearsal mode between the in and out points (i.e., nothing is recorded). [ROLL BACK] button This button is used to roll back the machine by the amount specified on the Locate Memory page (see page 224). If its pressed while the machine is stopped, the machine rolls back the specified amount and stops. If its pressed during playback, the machine rolls back the specified amount and then continues playing. [REHEARSAL] button This button is used to turn Rehearsal mode on and off. Its indicator lights up when Rehearsal mode is on. In Rehearsal mode, the machine enters Record-Rehearsal mode instead of actually recording when the [PLAY] and [REC] buttons are pressed together. Rehearsal mode can also be used with quick punch. [MTR] & [MASTER] buttons These mutually exclusive buttons are used to select the MTR or Master machines for control with the LOCATOR section. When the [MTR] button indicator is lit, the LOCATOR section controls machines set to MTR. When the [MASTER] button indicator is lit, the LOCATOR section controls machines set to MASTER. See "Configuring Machines" on page 220. Setting the Locate Memories, Pre-roll, Post-roll & Roll-back The locate points and the pre-roll, post-roll, and roll-back times can be set as follows. 1 Use the LOCATOR [DISPLAY] button to locate the Locate Memory page. 2 Use the cursor buttons to select the parameters, and use the Parameter wheel, INC/DEC buttons, and [ENTER] button to set them. LOCATE MEMORY 1-8, IN, OUT, and RTZ: These time values determine the points that will be located when the LOCATOR [1-8], [IN], [OUT], and [RTZ] buttons are pressed. Locate points can be specified in hours, minutes, seconds, and frames, the frame range being dependent on the frame rate setting on the Time Reference page (see page 171). DM2000-Owner's Manual