Yamaha DM2000 Owner's Manual - Page 45

Rear Panel 31 B STEREO OUT +4 dB (BAL) These balanced XLR-3-32-type connectors, nominal output level +4 dB, output the analog Stereo Out signal Female XLR plug and are typically connected the stereo inputs of a 2-track recorder. They are wired pin 1-ground, pin 2-hot (+), and pin 3-cold (-). See "Stereo Out Connectors" on page 82. 2 (hot) 3 (cold) 1 (ground) C SMALL CONTROL ROOM MONITOR OUT +4 dB (BAL) These balanced XLR-3-32-type connectors, nominal output level +4 dB, output the analog Small Control Room Monitor signal and are typically used to feed the control room's nearfield monitors. See "Control Room Monitoring" on page 132 for more information. Female XLR plug 2 (hot) 3 (cold) 1 (ground) D LARGE CONTROL ROOM MONITOR OUT +4 dB (BAL) These balanced XLR-3-32-type connectors, nominal output level +4 dB, output the analog Large Control Room Monitor signal and are typically used to feed the control room's main monitors. See "Control Room Monitoring" on page 132 for more information. Female XLR plug 2 (hot) 3 (cold) 1 (ground) E 2TR IN ANALOG 1 +4 dB (BAL) These balanced 1/4-inch TRS phone jacks, nominal input level +4 dB, are typically used to connect the analog stereo 1/4" TRS phone plug Tip (hot) Ring (cold) outputs of a 2-track recorder. Signals connected here can be monitored via the CONTROL ROOM MONITOR Sleeve (ground) OUT by pressing the CONTROL ROOM [2TR A1] button. In addition, this input can be patched to Input Channels or Insert Ins. See "2TR Analog INs" on page 49. F STEREO OUT -10 dBV (UNBAL) These unbalanced phono connectors, nominal output level -10 dBV, output the analog Stereo Out signal and are typically connected to the stereo inputs of a 2-track recorder. See "Stereo Out Connectors" on page 82. Phono plug Tip (hot) Sleeve (ground) G 2TR IN ANALOG 2 -10 dBV (UNBAL) These unbalanced phono connectors, nominal input level Phono plug Tip (hot) -10 dBV, are typically used to connect the analog stereo outputs of a 2-track recorder. Signals connected here can be monitored via the Sleeve (ground) CONTROL ROOM MONITOR OUTs by pressing the CONTROL ROOM [2TR A2] button. In addition, this input can be patched to Input Channels or Insert Ins. See "2TR Analog INs" on page 49. OMNI OUT Section 1 A OMNI OUT +4dB (BAL) These balanced 1/4-inch TRS phone jacks, nominal output level +4 dB, provide eight analog outputs that can be patched to the following: Bus Outs, Aux Sends, Matrix Sends, the Stereo Out, Insert Outs, Direct Outs, or Surround Monitor Channels. See "Omni Outs" on page 49. 1/4" TRS phone plug Tip (hot) Ring (cold) Sleeve (ground) DM2000-Owner's Manual