Yamaha DM2000 Owner's Manual - Page 301

Effects Parameters 287 AUTO PAN 5.1 Six input, six output autopanner for 5.1 surround. You can reset to the pan position specified by the OFFSET parameter by pressing the RESET button. Parameter Range Description SOURCE OFF, HOLD, INPUT, MIDI TRIG. LVL -60 to 0 dB TRG MASK 0-1000 ms TIME SPEED DIR. OFFSET HPF LPF 0.1 s-10.0 s 0.05 Hz-40.00 Hz Turn L, Turn R -180 to +180 degrees THRU, 21.2 Hz-8.00 kHz 50.0 Hz-16.0 kHz, THRU When set to OFF, the TRIGGER button is used to start autopan. When set to HOLD, autopan runs continuously. When set to INPUT, the input signal triggers autopan. When set to MIDI, a MIDI Note On message can be used to trigger autopan. Input trigger level (i.e., the signal level required to trigger panning when SOURCE set to INPUT) Trigger Mask specifies the time from when a trigger is received until the next trigger will be accepted. The time after which autopan starts once it's been triggered Autopan speed Autopan direction Pan offset High-pass filter cutoff frequency Low-pass filter cutoff frequency CHORUS 5.1 Six input, six output chorus for 5.1 surround. Parameter Range Description FREQ. AM DEPTH PM DEPTH MOD. DLY WAVE HPF LPF SYNC NOTE 0.05-40.00 Hz 0-100% 0-100% 0.0-400.0 ms Sine, Tri THRU, 21.2 Hz-8.00 kHz 50.0 Hz-16.0 kHz, THRU OFF/ON 1 Modulation speed Amplitude modulation depth Pitch modulation depth Modulation delay time Modulation waveform High-pass filter cutoff frequency Low-pass filter cutoff frequency Tempo parameter sync on/off Used in conjunction with TEMPO to determine FREQ. 1. DM2000-Owner's Manual