Yamaha DM2000 Owner's Manual - Page 26

12 Chapter 2-Control Surface & Rear Panel SELECTED CHANNEL Section ROUTING DISPLAY 1 2 3 4 5 6 SELECTED CHANNEL PHASE / INSERT DELAY DISPLAY INSERT ON AUX / MATRIX SEND DISPLAY ON FB MIX TIME DISPLAY LEVEL LEVEL LEVEL LEVEL 7 8 FOLLOW PAN STEREO DIRECT DYNAMICS BANK ON AUX 1 / MATRIX 1 AUX 5 AUX 9 ON AUX 2 / MATRIX 2 AUX 6 AUX 10 ON AUX 3 / MATRIX 3 AUX 7 AUX 11 ON AUX 4 / MATRIX 4 AUX 8 AUX 12 DISPLAY GATE / COMP GATE THRESHOLD COMP GATE ON COMP ON THRESHOLD PAN / SURROUND RANGE RATIO DISPLAY L ODD L R EQUALIZER R EVEN ATTACK ATTACK DECAY RELEASE HOLD GAIN LINK GRAB EFFECT DISPLAY CHANNEL ATT. COPY EQ ON PASTE LOW FREQUENCY Q GAIN dB 125 Hz kHz LOW MID FREQUENCY Q GAIN dB 1.00 Hz kHz HIGH MID FREQUENCY Q GAIN dB 4.00 Hz kHz HIGH FREQUENCY Q GAIN dB 10.0 Hz kHz The subsections of the SELECTED CHANNEL section are explained below. ROUTING 1 ROUTING DISPLAY 1 2 3 4 5 6 5 2 7 8 FOLLOW PAN STEREO DIRECT 34 A ROUTING DISPLAY button This button is used to select the following pages: Input Channel Routing, Bus to Stereo, and Bus to Stereo Library. See "Routing Input Channels" on page 75 and "Sending Bus Outs to the Stereo Out" on page 87 for more information. B FOLLOW PAN button This button determines whether or not the currently selected Input Channel's pan setting is applied to the Bus Outs. Its indicator lights up when it's pressed. See "Routing Input Channels" on page 75 for more information. C STEREO button This button is used to route the currently selected Input Channel to the Stereo Out. Its indicator lights up when it's pressed. See "Routing Input Channels" on page 75 for more information. D DIRECT button This button is used to route the currently selected Input Channel to its Direct Out. Its indicator lights up when it's pressed. See "Routing Input Channels" on page 75 for more information. DM2000-Owner's Manual