Canon imagePROGRAF W8400 W8400 User's Guide - Page 101

‹ Printing with Cut Sheets Important z Align and load parallel the cut sheets to the paper alignment line on the right of the platen. If the paper is loaded at an angle, an error will occur. If this happens, reload the paper straight. Note z If the release lever is open, the platen paper suction can be adjusted. If it is difficult to load the paper, adjust the suction using the [ ] button (stronger) and [ ] button (weaker) on the operation panel. z This printer uses vacuum to hold paper against holes in the platen. A warning may sound depending on the paper position, but this is not abnormal. z If the buzzer sounds, align the paper with the guide and try changing the position 1 mm to the left or right. z The suction time when the media is loaded is approx. 30 seconds. If the media cannot be loaded during suction, remove and then reinsert the paper. Suction will be performed again. 3 Lower the release lever, and close the top cover. 4 Press [ ] or [ ] to select the name of the media type then press the OK button. If the same type of media already matches the loaded media, just press the OK button. Media Type HW Coated An equals (=) mark is displayed to the left of the option to show the media type that has been selected, and the printer begins preparing to feed the cut sheets. The paper size and angle will be detected, and printing will be enabled if there are no problems. TOP Chapter 1 Basic Use Chapter 2 Using Various Media Chapter 3 Printing by Objective Chapter 4 Maintenance Chapter 5 Using the Printer in a Network Environment Chapter 6 Troubleshooting Chapter 7 Operating the Function Menu Contents 2- 40 Media Type is displayed. Index