Canon imagePROGRAF W8400 W8400 User's Guide - Page 93
Media Type, Close the top cover.
View all Canon imagePROGRAF W8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Printing with Rolls Media 9 Hold the end of the paper, and lift the release lever. Note z If the release lever is open, the platen paper suction can be adjusted. If it is difficult to load the paper, adjust the suction using the [ ] button (stronger) and [ ] button (weaker) on the operation panel. 11 Close the top cover. 10 While gently pulling out the center of the leading edge of the roll media to the ejection guide (f), align the right edge of the media with the right side of the paper alignment line (g), then pull down the release lever. g f 2- 32 Important z Make sure to carry out Step 9 and 10. Otherwise, the paper may not be feed straight, or the paper may become wrinkled causing a paper jam or friction on the printhead. z Do not pull strongly on the roll media when you align it with the paper alignment line (g). The roll media may not feed out straight in some cases. Media Type is displayed. 12 Press the [ ] or [ ] buttons to select the loaded media type, and then press the OK button. If the same type of media already matches the loaded media, just press the OK button. Media Type HW Coated The selection is prefixed with an equals sign (=) to indicate the roll media type that is selected. TOP Chapter 1 Basic Use Chapter 2 Using Various Media Chapter 3 Printing by Objective Chapter 4 Maintenance Chapter 5 Using the Printer in a Network Environment Chapter 6 Troubleshooting Chapter 7 Operating the Function Menu Contents Index