Canon imagePROGRAF W8400 W8400 User's Guide - Page 89

‹ Printing with Rolls Media Printing with Rolls Media Loading Roll Media This is the general procedure for loading roll media. After printing remove the completed printout and any media loaded on the platen. (→ P.2-35, P.2-42) On the operation panel, select the roll media source. (→ P.2-28) Load the roll media in the roll holder slot. (→ P.2-29) Load the roll media on the platen. (→ P.2-32) On the printer operation panel, select the media type. (→ P.2-32) Adjust the amount of media feed. (→ P.4-43) Start the print job from the computer. (→ P.1-38) Important z Make sure to turn off the power supply to the printer before loading the roll media. Further, if the loaded media differs from the media type setting, the print quality may be reduced. z The roll media remaining detection function cannot be used for Tracing Paper or Translucent Matte Film. When using a Tracing Paper roll or Translucent Matte Film roll, switch off the roll media remaining detection function before loading the roll. „ Selecting the Paper Source When printing on roll media, select roll media as the paper source using the operation panel. 1 Press and hold the Paper Source button for 1 second or more to light the Roll Media lamp. Data Message Offline Feed Paper Information Power Cleaning (3 sec.) Stop/Eject (1 sec.) Online Offline Menu When cut paper is loaded, the printer will display Remove CutSheet?. If you have loaded another roll, press and hold the Stop/Eject button for 1 second or more to display Remove RllMedia?. 2 If the cut sheet or roll media is set to the printer, press the OK button. Remove CutSheet? Press OK/Stop Remove the cut sheets or roll media. (→ P.2-35, P.2-42) TOP Chapter 1 Basic Use Chapter 2 Using Various Media Chapter 3 Printing by Objective Chapter 4 Maintenance Chapter 5 Using the Printer in a Network Environment Chapter 6 Troubleshooting Chapter 7 Operating the Function Menu Contents 2- 28 Index