Garmin G2000 Pilots Guide - Page 142

SySteM overview FligHt inStruMentS Audio And cnS TRANSMIT/RECEIVE INDICATIONS During COM transmission, a white TX appears by the active COM frequency. During COM signal reception, a white RX appears by the active COM frequency. Transmit Indicator Receive Indicator Transmit Indicator Receive Indicator eiS Audio & cnS FligHt MAnAgeMent HAZArd AvoidAnce AFcS AdditionAl FeAtureS Transmit Indicator on PFD Receive Indicator on PFD Figure 4-5 COM Radio Transmit and Receive Indications coM Frequency tuning Selecting a COM frequency using the Touchscreen Controller: 1) Touch the COM1 STBY Button or COM2 STBY Button in the CNS Bar to display the COM1/COM2 Standby Screen. 2) Use the keypad to select the frequency. 3) Touch the Enter Button to accept the new frequency as the COM1/COM2 standby frequency; or touch the XFER Button to accept the new frequency as the COM1/COM2 active frequency and transfer the previously active frequency to the standby frequency. Or: 1) Press the small right knob to select the COM desired for tuning (selected standby frequency is light blue). 2) Turn the large and small right knobs to tune the frequency (Large knob increases/decreases MHz; Small knob increases/decreases kHz). 3) Press the small right knob to enter the new frequency as the standby frequency; or press and hold the small right knob to transfer the new standby frequency to the active frequency. 128 Garmin G2000 Pilot's Guide for the Cessna T240 190-01263-01 Rev. A AppendiceS indeX