Garmin G2000 Pilots Guide - Page 171

SYSTEM OVERVIEW Audio and CNS Entering a Transponder Code Entering a transponder code with the keypad: 1) Touch the Transponder Mode Button to display the Transponder Screen. 2) Use the keypad to select the desired code. 3) Touch the Enter Button to enter the new code, or wait approximately two seconds for automatic entry. Transponder Code Entry FLIGHT INSTRUMENTS EIS AUDIO & CNS FLIGHT MANAGEMENT HAZARD AVOIDANCE AFCS VFR Button Figure 4-43 Transponder Code Entry Entering a transponder code with the knobs: 1) Touch the Transponder Mode Button to display the Transponder Screen. 2) Turn the large right knob one click either way to place the editing cursor on the first digit of the existing code. 3) Turn the small right knob to enter the first digit. 4) Turn the large right knob to move the cursor to the next digit. 5) Turn the small right knob to enter the next digit, repeat steps 4 and 5 until complete. 6) Touch the Enter Button, or push the small right knob, to enter the new code. Or: 1) Touch the Transponder Mode Button to display the Transponder Screen. 2) Turn the small right knob one click either way to erase the previous code and place the editing cursor on the first digit. 3) Turn the small right knob to enter the first digit. 4) Turn the large right knob to move the cursor to the next digit. 5) Turn the small right knob to enter the next digit, repeat steps 4 and 5 until complete. 6) Touch the Enter Button, or push the small right knob, to enter the new code. Pressing the Cancel Button before code entry is complete cancels code entry and restores the previous code. 190-01263-01 Rev. A Garmin G2000 Pilot's Guide for the Cessna T240 157 ADDITIONAL FEATURES APPENDICES INDEX