Garmin G2000 Pilots Guide - Page 599

SYSTEM OVERVIEW FLIGHT INSTRUMENTS EIS AUDIO & CNS FLIGHT MANAGEMENT AVOIDANCE Appendix B 7) Touch a button from the list to view database information associated with that display (MFD1, PFD1, GTC1). 8) Scroll through the database information to view database status. 9) Monitor the Sync Status of the updated databases in the Database Window. Wait for all databases to complete synchronizing, indicated by 'Complete' being displayed as seen in Figure B-8. 10) Remove and reapply power to the system. 11) From the Home Screen on the Touchscreen Controller, touch Utilities > Setup > Avionics Status. 12) If necessary, touch the Database tab. 13) Touch a button from the list to view database information for each display (MFD1, PFD1, GTC1). Verify all have been appropriately updated. Updating Terrain and ChartView Databases These databases must be copied to all three Supplemental Data Cards: 1) With system power OFF, remove the Supplemental Data Card from the bottom card slots of the PFD and MFD. 2) Update the terrain and/or ChartView databases on each of the Supplemental Data Cards. 3) Insert the updated Supplemental Data Cards into the bottom card slots of the PFD and MFD. 4) Apply power to the system, check that the databases are initialized and displayed on the Power-Up Display (Figure B-11). A 'Verifying' message may be seen. If this message is present, wait for the system to finish loading before proceeding to step 5. 5) From the Home Screen on the Touchscreen Controller, touch Utilities > Setup > Avionics Status. 6) If necessary, touch the Database tab. 7) Touch a button from the list to view database information associated with each display (MFD1, PFD1, GTC1). 8) Scroll through the database information to verify all databases are displaying the desired version information. 9) Remove power from the system. Magnetic Field Variation Database Update The Magnetic Field Variation Database is loaded as part of the navigation database, but is copied to, and resides within each AHRS (GRS1 and GRS2). At startup, the system compares the MV DB within the navigation database to that presently residing in each AHRS (GRS1 and GRS2). When a new navigation database is loaded, the system may determine the newly loaded MV DB within the navigation database is newer than that residing in each AHRS. In this case, the system will prompt for an update. This prompt is displayed on the Touchscreen Controller (GTC), as shown in Figure B-12. Note, in this example, GRS1 is the first AHRS to indicate an update is available. In actuality, this is dependent on which AHRS is the first to report status to the system. GRS2 may be displayed before GRS1. The order is not important, only that both AHRS be updated. HAZARD AFCS ADDITIONAL FEATURES APPENDICES INDEX 190-01263-01 Rev. A Garmin G2000 Pilot's Guide for the Cessna T240 585