Garmin G2000 Pilots Guide - Page 152

SYSTEM OVERVIEW FLIGHT INSTRUMENTS EIS AUDIO & CNS Audio and CNS 4.3 NAV Operation NAV Radio Selection and Activation The active NAV frequency selected for navigation is shown on the PFD. Active and Standby NAV frequencies are shown on the Touchscreen Controller. A NAV radio is selected for navigation by selecting the Active NAV Softkey located on the PFD. The NAV frequency selected for navigation is displayed in green. Selecting the Active NAV Softkey once selects NAV1 as the navigation radio. Selecting the Active NAV Softkey a second time selects NAV2 as the navigation radio. Selecting the Active NAV Softkey a third time activates FMS mode. Selecting the Active NAV Softkey again cycles back to NAV1. The three navigation modes that can be cycled through are: • VOR1 (or LOC1) - If NAV1 is selected, a green single line arrow (shown) labeled either VOR1 or LOC1 is displayed on the HSI and the active NAV1 frequency is displayed in green. • VOR2 (or LOC2) - If NAV2 is selected, a green double line arrow (not shown) labeled either VOR2 or LOC2 is displayed on the HSI and the active NAV2 frequency is displayed in green. • FMS - If FMS Mode is selected, a magenta single line arrow (not shown) appears on the HSI and neither NAV radio is selected. Both active NAV frequencies are displayed in white on the Touchscreen Controller. NAV1 Active Frequency and ID The NAV Radio is selected by pressing the Active NAV Softkey Figure 4-17 Selecting a NAV Radio for Navigation See the Flight Instruments Section for selecting the DME and Bearing Information windows and using VOR or ADF as the source for the bearing pointer. FLIGHT MANAGEMENT HAZARD AVOIDANCE AFCS ADDITIONAL FEATURES APPENDICES INDEX 138 Garmin G2000 Pilot's Guide for the Cessna T240 190-01263-01 Rev. A