Garmin G2000 Pilots Guide - Page 58
Enabling/Disabling Electronic Stability & Protection, Setting COM Channel Spacing
View all Garmin G2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
SYSTEM OVERVIEW FLIGHT INSTRUMENTS EIS AAUUDDI&IOOCPN&ASCNENLS FLIGHT MANAGEMENT System Overview 3) Touch the GPS CDI button (button displays current GPS CDI range in light blue). 4) Touch one of the following GPS CDI Range Buttons: 0.30 NM, 1.00 NM, 2.00 NM, or AUTO. COM Channel Spacing NOTE: 8.33 kHz VHF communication frequency channel spacing is not approved for use in the United States. Select the 25.0 kHz channel spacing option for use in the United States. The 'COM Channel Spacing' datafield allows the pilot to select 8.33 kHz or 25.0 kHz COM frequency channel spacing. Setting COM Channel Spacing: 1) From the Home, touch Utilities > Setup > Avionics Settings. 2) If necessary, touch the System tab. 3) Scroll to and touch the COM Channel Spacing Button (button displays the current spacing setting in light blue). 4) Touch either the 8.33 kHz or 25.0 kHz Buttons. Electronic Stability & Protection (ESP) Refer to the Additional Features Section for more information on Electronic Stability & Protection. Enabling/Disabling Electronic Stability & Protection: 1) From Home, touch Utilities > Setup > Avionics Settings. 2) If necessary, touch the System tab. 3) Scroll to and touch the Stability & Protection Enable Button. Electronic Stability and Protection is enabled when button annunciator is green, disabled when gray. The Electronic Stability & Protection feature is enabled on each power cycle. Nearest Airports Nearest airport matching criteria (such as minimum runway length and/or surface type) can be entered to prevent airports with small runways or runways that are not of appropriate surface from being displayed in the list as nearest airports . Default settings are zero feet (or meters) for runway length and "HARD/SOFT" for runway surface type. Setting the Nearest Airport surface matching criteria: 1) From the Home, touch Utilities > Setup > Avionics Settings. 2) If necessary, touch the System tab. 3) Scroll to and touch the Nearest Airport Runway Surface button (button displays current runway surface selection in light blue). 4) Touch one of the following runway surface buttons: Any, Hard Only, Hard/Soft, or Water. HAZARD AVOIDANCE AFCS ADDITIONAL FEATURES APPENDICES INDEX 44 Garmin G2000 Pilot's Guide for the Cessna T240 190-01263-01 Rev. A