Garmin G2000 Pilots Guide - Page 26

SYSTEM OVERVIEW FLIGHT INSTRUMENTS EIS AAUUDDI&IOOCPN&ASCNENLS System Overview Level 1 Level 2 OBS Active NAV Sensors AHRS Settings CAS CAS Up CAS Dn Level 3 Altitude Units COM1 121.5 AHRS 1 AHRS 2 Level 4 Description Displays softkeys to select altitude unit parameters. Meters IN HPA When enabled, displays current altitude and selected altitude in meters in addition to feet. Press to display the BARO setting as inches of mercury Press to display the BARO setting as hectopacals. Tunes COM1 to the emergency frequency. Selects OBS mode on the CDI when navigating by GPS (only available with active leg). When OBS is on, the softkey annunciator is green. Cycles through FMS, VOR1, and VOR2 navigation modes on the CDI. Displays the sensor selection softkeys. Displays the AHRS selection softkeys. Selects the number 1 AHRS. The softkey annunciator is green when selected. Selects the number 2 AHRS. The softkey annunciator is green when selected. Available only when the list of CAS messages is longer the allotted window. Pressing softkey displays CAS scrolling softkeys. Scrolls up through the CAS message list Scrolls down through the CAS message list GDU Controller The GDU Controller is a pedestal-mounted user interface allowing for ease of data entry, PFD operation, NAV/ COM tuning. Many procedures in this Pilot's Guide can be performed using the GDU Controller. COM radio tuning can be accomplished using the PFD controller. Pressing the COM/NAV Button displays/ removes the COM/NAV Window, which allows for the selection of the active and standby frequencies, mics, and the com monitoring audio source. The Selected Source Frequency Box appears in the upper-right of the PFD with the active com source in white and frequency in green (refer to the Audio and CNS Section for more information about NAV/COM tuning). FLIGHT MANAGEMENT HAZARD AVOIDANCE AFCS ADDITIONAL FEATURES APPENDICES INDEX 12 Garmin G2000 Pilot's Guide for the Cessna T240 190-01263-01 Rev. A