Garmin G2000 Pilots Guide - Page 144

SYSTEM OVERVIEW FLIGHT INSTRUMENTS EIS AUDIO & CNS Audio and CNS 1) Touch the Audio & Radios Button to display the Audio & Radios Screen. 2) Touch the COM1/COM2 frequency button to display the COM1/COM2 Standby Screen. 3) Use the keypad to select the desired frequency. 4) Touch the Enter Button to accept the new frequency as the COM1/COM2 standby frequency; or touch the XFER Button to accept the new frequency as the COM1/COM2 active frequency and transfer the previously active frequency to the standby frequency. Selecting a COM frequency using the GDU Controller: 1) On the GDU Controller, press the COM/NAV Button to display the COM/NAV Window on the PFD. 2) Turn the large PFD Knob to move the cursor to the SOURCE field. 3) Turn either PFD Knob to select the desired COM. 4) Press the ENT Key or the small PFD Knob to accept the selection and move the cursor to the STBY frequency field. 5) Turn the small PFD Knob one click to activate the editing cursor (flashing). 6) Turn the large and small PFD knobs to select the frequency (Large knob increases/decreases MHz; Small knob increases/decreases kHz) 7) Press the ENT Key or the small PFD Knob to accept the selection and move the cursor to the XFER? field. 8) Press the ENT Key or the small PFD Knob to accept the new frequency as the COM1/COM2 active frequency and transfer the previously active frequency to the standby frequency Figure 4-8 Frequency Tuning from the GDU Controller FLIGHT MANAGEMENT HAZARD AVOIDANCE AFCS ADDITIONAL FEATURES APPENDICES INDEX 130 Garmin G2000 Pilot's Guide for the Cessna T240 190-01263-01 Rev. A