Garmin G2000 Pilots Guide - Page 97

SYSTEM OVERVIEW FLIGHT INSTRUMENTS EIS AUDIO PANEL & CNS Flight Instruments OBS Mode NOTE: VNV is inhibited while automatic waypoint sequencing has been suspended. Enabling Omni-bearing Selector (OBS) Mode suspends the automatic sequencing of waypoints in a GPS flight plan (FMS must be the selected navigation source), but retains the current "active-to" waypoint as the navigation reference even after passing the waypoint. 'OBS' is annunciated to the lower right of the aircraft symbol when OBS Mode is selected. While OBS Mode is enabled, a course line is drawn through the "active-to" waypoint on the moving map. If desired, the course to/from the waypoint can now be adjusted. When OBS Mode is disabled, the GPS flight plan returns to normal operation with automatic sequencing of waypoints, following the course set in OBS Mode. The flight path on the moving map retains the modified course line. FMS Selected OBS Mode Enabled OBS Softkey Figure 2-29 Omni-bearing Selector (OBS) Mode OBS Softkey Enabling/disabling OBS Mode while navigating a GPS flight plan: 1) Select the OBS Softkey to select OBS Mode. 2) Turn the CRS Knob to select the desired course to/from the waypoint. Press the CRS Knob to synchronize the Selected Course with the bearing to the next waypoint. 3) Select the OBS Softkey again to return to automatic waypoint sequencing. FLIGHT MANAGEMENT AVOIDANCE HAZARD AFCS ADDITIONAL FEATURES APPENDICES INDEX 190-01263-01 Rev. A Garmin G2000 Pilot's Guide for the Cessna T240 83