Garmin G2000 Pilots Guide - Page 582
System Message, Comments, Non Wgs84 Wpt, Traffic Fail, Failed Path, Large Mag Variance, Check Crs
![]() |
View all Garmin G2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 582 highlights
Appendix A SYSTEM OVERVIEW FLIGHT INSTRUMENTS EIS AUDIO & CNS AVOIDANCE MANAGEMENT FLIGHT HAZARD System Message Comments NON WGS84 WPT - Do not GPS for navigation to [xxxx] The position of the selected waypoint [xxxxx] is not calculated based on the WGS84 map reference datum and may be positioned in error as displayed. Do not use GPS to navigate to the selected non-WGS84 waypoint. TRAFFIC FAIL - Traffic device The G2000 is no longer receiving data from the traffic system. The traffic device should be has failed. serviced. FAILED PATH - A data path has failed. A data path connected to the GDU or the GIA 63/63W has failed. LARGE MAG VARIANCE - Verify all course angles. The GDU's internal model cannot determine the exact magnetic variance for geographic locations near the magnetic poles. Displayed magnetic course angles may differ from the actual magnetic heading by more than 2°. SCHEDULER [#] - . Message criteria entered by the user. SVT DISABLED - Out of available terrain region. Synthetic Vision is disabled because the aircraft is not within the boundaries of the installed terrain database. SVT DISABLED - Terrain DB Synthetic Vision is disabled because a terrain database of sufficient resolution (9 arc-second resolution too low. or better) is not currently installed. TERRAIN DISABLED - Terrain Awareness DB resolution too low. TAWS is disabled because a terrain database of sufficient resolution (9 arc-second or better) is not currently installed. TRN AUD FAIL - Trn Awareness audio source unavailable. TAWS is disabled because an aural alert audio source is unavailable. TRN AUD CFG - Trn Awareness audio config error. TAWS is disabled because the audio configuration is invalid. The system should be serviced. Service req'd. CHECK CRS - Database course for LOC1 / [LOC ID] is [CRS]°. Selected course for LOC1 differs from published localizer course by more than 10 degrees. CHECK CRS - Database course for LOC2 / [LOC ID] is [CRS]°. Selected course for LOC2 differs from published localizer course by more than 10 degrees. [PFD1 or MFD1] CARD 1 REM - [PFD1 or MFD1] card 1 was removed. Reinsert card. The SD card was removed from the top card slot of the PFD or MFD. The SD card needs to be reinserted. [PFD1 or MFD1] CARD 2 REM - Card 2 was removed. Reinsert card. The SD card was removed from the bottom card slot of the PFD or MFD. The SD card needs to be reinserted. [PFD1 or MFD1] CARD 1 ERR - [PDF1 or MFD1] card 1 The SD card in the top card slot of the PFD or MFD contains invalid data. is invalid. [PFD1 or MFD1] CARD 2 ERR - [PFD1 or MFD1] Card 2 The SD card in the bottom card slot of the PFD or MFD contains invalid data. is invalid. [PFD1 or MFD1] CARD 3 REM - Card 3 was removed. Reinsert card. The internal SD card was removed from the PFD or MFD. The system should be serviced. 568 Garmin G2000 Pilot's Guide for the Cessna T240 190-01263-01 Rev. A AFCS ADDITIONAL FEATURES APPENDICES INDEX
![](/manual_guide/products/garmin-g2000-pilots-guide-b2a7ad8/582.png)