HP Xw6600 HP xw6600 Workstation Service and Technical Reference Guide - Page 102
Installing a SATA hard drive,
UPC - 883585731121
View all HP Xw6600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
4. Lift the green drive-lock release tab (1) and slide the hard drive out of the chassis (2), as shown: Figure 4-49 Removing the SATA hard drive 5. As shown in the following figure, remove the hard drive body from the drive mounting rails and retain the rails for later use. Figure 4-50 Removing the hard drive body from the hard drive mounting rails Installing a SATA hard drive NOTE: Each workstation hard drive bay can be configured at the factory to hold three small form factor hard drives instead of two standard size drives. To obtain the option kit documentation for removal and replacement of small form factor hard drives, refer to the HP xw Workstation series - Small form factor bay converter and hard drive installation user guide at: http://www.hp.com/support/xw6600 manuals 92 Chapter 4 Removal and replacement procedures ENWW