HP Xw6600 HP xw6600 Workstation Service and Technical Reference Guide - Page 142
Table 5-18, POST error messages, continued - cpu heatsink
UPC - 883585731121
View all HP Xw6600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
Table 5-18 POST error messages (continued) Screen message Probable cause Recommended action 514-CPU or Chassis Fan not CPU or chassis fan is missing, not detected connected, or defective 1. Insure the processor or chassis fan is installed and connected properly. 2. Replace the processor fan or the chassis fan. 515-CPU Overtemp ocurrred Insufficient processor cooling, or processor defect 1. If necessary, add a heatsink to processor and ensure proper operation. 516-PCI fan not detected 2. Replace the processor. Missing PCI fan, or disconnected fan ● Add a PCI fan if necessary. cable ● Insure proper PCI fan cable connection and operation. 517-Low power CPU heatsink(s) detected for high power CPUs 518-Power supply wattage insufficient for hardware configuration Inadequate heatsink installed Replace the low power heatsink with a high power heatsink. Workstation configuration requires ● more power than the power supply can provide ● Reduce the workstation power consumption. Replace the power supply with a high output power supply. 601-Diskette Controller Error Diskette controller circuitry or diskette 1. Run the Computer Setup (F10) utiltiy. drive circuitry incorrect 2. Verify cabling and replace defective cables if necessary. 3. Clear CMOS. 4. Replace diskette drive. 5. Replace the system board. 605-Diskette Drive Type Error Mismatch in drive type 1. Run the Computer Setup (F10) Utility. 2. Disconnect any other diskette controller devices (tape drives). 3. Clear the CMOS. 610-External Storage Device External storage device not detected, 1. Ensure the external device is present and Failure improperly connected, or defective connected properly. 2. Replace the external device. 912-Computer Cover Has N/A Been Removed Since Last System Start Up No action required. 914- Hood Lock Coil is not Connected Mechanism is missing or not connected 1. Reconnect or replace the missing mechanism. 2. Reseat or replace the missing mechanism cable. 921-Device in PCI Express Missing, improperly seated, or Slot failed to initialize defective card 1. Ensure the card is installed. 2. Reseat the card. 3. Replace the card. 922-Fatal error in slot # Fatal error occurred in the designated Move the card to a different slot. If the problem persists, slot replace the card. 132 Chapter 5 System diagnostics and troubleshooting ENWW