HP Xw6600 HP xw6600 Workstation Service and Technical Reference Guide - Page 71
Hood sensor (Smart cover sensor), Front bezel, Removing the front bezel
UPC - 883585731121
View all HP Xw6600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Hood sensor (Smart cover sensor) To remove the hood sensor: 1. Disconnect power from the system (see Predisassembly procedures on page 52). 2. Remove the side access panel (see Side access panel on page 58). 3. Disconnect the white 1x3 hood sensor connector from the in-line connector attached to the front panel harness. 4. Slide the hood sensor forward, push it down, and remove it from the chassis, as shown: Figure 4-9 Removing the hood sensor 5. To replace the hood sensor, reverse the previous steps. Front bezel This section describes how to remove and replace the front bezel. Removing the front bezel To remove the front bezel: 1. Remove the side access panel. ENWW Removing and replacing components 61
Hood sensor (Smart cover sensor)
To remove the hood sensor:
1.
Disconnect power from the system (see
Predisassembly procedures
on page
52
).
2.
Remove the side access panel (see
Side access panel
on page
58
).
3.
Disconnect the white 1x3 hood sensor connector from the in-line connector attached to the front
panel harness.
4.
Slide the hood sensor forward, push it down, and remove it from the chassis, as shown:
Figure 4-9
Removing the hood sensor
5.
To replace the hood sensor, reverse the previous steps.
Front bezel
This section describes how to remove and replace the front bezel.
Removing the front bezel
To remove the front bezel:
1.
Remove the side access panel.
ENWW
Removing and replacing components
61