HP Xw6600 HP xw6600 Workstation Service and Technical Reference Guide - Page 56
Start, Control Panel>Power Options, Advanced, Hibernate, In Power Options Properties, select
UPC - 883585731121
View all HP Xw6600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
To change the power button configuration: 1. Select Start, and then select Control Panel>Power Options. 2. In Power Options Properties, select the Advanced tab. 3. In the Power Button section, select Hibernate. Hibernate must be enabled in the Hibernate tab. After configuring the power button to function as a button, you can press the power button to put the system in a low power state. Press the button again to bring the system out of this low power state to full power state. To completely turn off power to the system, press and hold the power button for four seconds. CAUTION: Do not use the power button to power off the workstation unless the system is not responding. Turning off the power without operating system interaction can cause damage to, or loss of data on, the hard drive. 46 Chapter 3 System management ENWW