HP LaserJet 9040/9050 Service Manual - Page 158
lever callout 3.
View all HP LaserJet 9040/9050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Feed-drive assembly 1 Remove the following FRUs: • Back cover. See page 109. • High-voltage power supply. See page 137. • DC controller. See page 138. 2 Disconnect the drum motor. 3 Open the front cover. 4 Press the white button on the cartridge release lever (callout 1, page 119), and then rotate the lever clockwise until it locks into place. 5 Face the back of the printer. 6 Pinch the two black tabs (callout 2) together with needle-nose pliers to release the activation lever (callout 3). 7 Remove three gold screws (callout 4). 8 Remove the feed-drive assembly. 32 2 42 Figure 89. Note Feed-drive assembly To reinstall Be sure to reconnect the activation lever. 142 Chapter 6 Removal and replacement
142
Chapter 6 Removal and replacement
Feed-drive assembly
1
Remove the following FRUs:
•
Back cover. See page 109.
•
High-voltage power supply. See page 137.
•
DC controller. See page 138.
2
Disconnect the drum motor.
3
Open the front cover.
4
Press the white button on the cartridge release lever (callout 1, page 119), and then rotate the
lever clockwise until it locks into place.
5
Face the back of the printer.
6
Pinch the two black tabs (callout 2) together with needle-nose pliers to release the activation
lever (callout 3).
7
Remove three gold screws (callout 4).
8
Remove the feed-drive assembly.
Figure 89.
Feed-drive assembly
To reinstall
Note
Be sure to reconnect the activation lever.
2
2
2
2
3
4