Netgear GS724Tv4 Software Administration Manual - Page 120
Multicast Router VLAN Configuration, Querier Configuration, To con the Multicast Router
View all Netgear GS724Tv4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
GS716Tv3, GS724Tv4, and GS748Tv5 Smart Switches management. The default value for the multicast router expiration time is zero, which indicates an infinite time-out, that is, no expiration. To configure the Multicast Router: 1. Select Snooping > Multicast Router Configuration. 2. Select each interface to configure. For information about how to select and configure one or more ports or LAGs, see Configuring Interface Settings on page 28. 3. Use the Multicast Router field to enable or disable Multicast Router on the selected interface. 4. Click the Apply button. Multicast Router VLAN Configuration The statically configured router attached (VLAN, Interface) is added to the learned multicast router attached interface list if the interface is active and is a member of the VLAN. Unlike in the previous release of the system firmware, snooping dynamic learning mode (snooping interface mode or snooping VLAN mode) does not need not be enabled on the interface. The dynamic learning mode is applicable only for dynamically learnt multicast router information (Queries from an attached true Querier). To configure the multicast router VLAN: 1. Select Switching > Multicast > MLD Snooping > Multicast Router Configuration VLAN Configuration. 2. From the Interface menu, select the interface to configure. 3. In the VLAN ID field, specify the VLAN ID for which the multicast router mode is to be enabled or disabled. 4. From the Multicast Router field, select Enable to enable the multicast router on the selected interface, or select Disable to disable the multicast router on the interface. 5. Click the Apply button. Querier Configuration Use this screen to enable or disable the MLD Querier Configuration feature, specify the IP address of the router to perform the querying, and configure the related parameters. To configure the querier settings: 1. Select Switching > Multicast > MLD Snooping > Querier Configuration. 2. Next to the Querier Admin Mode field, enable or disable the administrative mode for MLD snooping querier. 3. In the Querier Address field, specify the snooping querier address to be used as source address in periodic MLD queries. This address is used when no address is configured on the VLAN on which query is being sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and x::x. Configuring Switching 120