Dell PowerEdge 2321DS User Manual - Page 29
To install the 2161DS-2/4161DS Remote Console Switch 1U four point
View all Dell PowerEdge 2321DS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
3 Mount the switch assembly to the rack by inserting the three mounting hooks on one side of the bracket into square holes in the vertical rack. 4 Press down until the blue push button pops out and clicks. Figure 2-1. OU Mounting Bracket Installation To install the 2161DS-2/4161DS Remote Console Switch 1U four point switch mounting bracket: 1 Remove the screws on each side of the 1U four-point switch and set them aside to attach to the front 1U bracket pieces later. 2 Line up the vent holes in the "long side" of the kit's front brackets with the vent holes in the switch. NOTE: The switch vent holes must not be covered by the bracket, which will occur if installed on the wrong side of the switch. 3 Line up the screw holes in the bracket with the screw holes in the switch. 4 With a Phillips screwdriver, fasten the front mounting brackets to the switch using two screws on each side. Installation 12