Ricoh 3245 Fax Reference - Page 82
Stamp
UPC - 026649128660
View all Ricoh 3245 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Other Transmission Features Stamp The optional ADF is required. ❒ A paper jam during Parallel Memory Transmission may cause the transmission to be failed even if stamping is performed. When sending a fax message using the ADF, the machine can stamp a circle mark at the bottom of the original. ❒ You cannot turn the Stamp function on or off while a document is being scanned. When sending a two-sided document, the document is marked at the bottom of the front page and top of A Place the original, and then select the scan settings you require. the rear page. This stamp indicates Reference that the original has been successfully stored in memory for Memory Trans- 4 mission, or successfully sent by Immediate Transmission. p.11 "Placing Originals", Facsimile Reference p.28 "Scan Settings", Facsimile Reference B Press [Sub TX Mode]. Note ❒ Stamp only works when scanning from the ADF. ❒ When the stamp starts getting lighter, replace the cartridge. See "Replacing the Stamp Cartridge", General Settings Guide. ❒ If a page was not stamped even though the Stamp function is turned on, you need to resend that page. ❒ If you use this function often, you can set the default in General Settings and Adjustment so that this function is always on. In this case, Stamp can easily be turned off for any single transmission by pressing [Stamp]. See p.144 "General Settings/Adjustment". C Press [Stamp], and then press [OK]. Note ❒ To cancel the stamp, press [Stamp] again before pressing [OK]. D Specify the destination, and then press the {Start} key. 72