Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 102

Parameters To return to the default setting, use the no ip tftp source-interface interface command. interface Enter the following keywords and slot/port or number information: • For Loopback interfaces, enter the keyword loopback then a number from zero (0) to 16383. • For a Port Channel, enter the keyword port-channel then a number. The range is 1 to 128. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For VLAN interface, enter the keyword vlan then a number from 1 to 4094. Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.5.1.0 8.2.1.0 8.1.1.0 7.6.1.0 7.5.1.0 E-Series Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4820T. Added support for 4-port 40G line cards on ExaScale. Increased number of VLANs on ExaScale to 4094 (was 2094). Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Original command Control and Monitoring 102