Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1409

To remove the peer from a mesh group, use the no ip msdp mesh-group {name} {peer address} command. Parameters name peer address Enter a string of up to 16 characters long for as the mesh group name. Enter the peer address in a dotted decimal format (A.B.C.D.). Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.5(0.1) 8.3.19.0 8.3.11.1 8.3.7.0 6.2.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced Usage Information An MSDP mesh group is a mechanism for reducing SA flooding, typically in an intradomain setting. When some subset of a domain's MSDP speakers are fully meshed, they can be configured into a mesh-group. If member X of a mesh-group receives a SA message from an MSDP peer that is also a member of the mesh-group, member X accepts the SA message and forwards it to all of its peers that are not part of the meshgroup. However, member X cannot forward the SA message to other members of the mesh-group. ip msdp originator-id Configure the MSDP Originator ID. C9000 Series Syntax ip msdp originator-id {interface} Multicast Source Discovery Protocol (MSDP) 1409