Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2063

snmp-server user Configure a new user to an SNMP group. C9000 Series Syntax snmp-server user name {group_name remote ip-address udp-port portnumber} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv {des56 | aes128} priv password] [access access-list-name | ipv6 access-list-name | access-list-name ipv6 access-list-name] To remove a user from the SNMP group, use the no snmp-server user name {group_name remote ip-address udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv {des56 | aes128} priv password] [access access-list-name | ipv6 accesslist-name | access-list-name ipv6 access-list-name] command. Parameters name group_name Enter the name of the user (not to exceed 20 characters), on the host that connects to the agent. Enter a text string (up to 20 characters long) as the name of the group. The following groups are created for mapping to read/ write community/security-names (defaults): • v1v2creadu - maps to a community with ro permissions. • 1v2cwriteu - maps to a community rw permissions. remote ip-address Enter the keywords udp-port then the user datagram protocol (UDP) port number on the remote device. The range is from 0 to 65535. The default is 162. udp-port portnumber Enter the keywords udp-port then the UDP (User Datagram Protocol) port number on the remote device. The range is from 0 to 65535. The default is 162. 1 | 2c | 3 (OPTIONAL) Enter the security model version number (1, 2c, or 3): • 1 is the least secure version. • 3 is the most secure of the security modes. • 2c allows transmission of informs and counter 64, which allows for integers twice the width of what is normally allowed. The default is 1. Simple Network Management Protocol (SNMP) and Syslog 2063