Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2176

Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The following describes the show ntp associations command shown in the Example below. Field (none) Description One or more of the following symbols could be displayed: • * means synchronized to this peer. • # means almost synchronized to this peer. • + means the peer was selected for possible synchronization. • - means the peer is a candidate for selection. • ~ means the peer is statically configured. remote ref clock st when poll reach delay Displays the remote IP address of the NTP peer. Displays the IP address of the remote peer's reference clock. Displays the peer's stratum, that is, the number of hops away from the external time source. A 16 in this column means the NTP peer cannot reach the time source. Displays the last time the switch received an NTP packet. Displays the polling interval (in seconds). Displays the reachability to the peer (in octal bitstream). Displays the time interval or delay for a packet to complete a round-trip to the NTP time source (in milliseconds). System Time and Date 2176