Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1491

Example Field aid: chk: aut: auk: keyid: to: dst: netmask: pri: N, MC, E, T hi: di: dr: bdr: Description Displays the Autonomous System ID. Displays the OSPF checksum. States if OSPF authentication is configured. One of the following is listed: • 0 - no authentication configured • 1 - simple authentication configured using the ip ospf authentication-key command • 2 - MD5 authentication configured using the ip ospf message-digest-key command If the ip ospf authentication-key command is configured, this field displays the key used. If the ip ospf message-digest-key command is configured, this field displays the MD5 key Displays the interface to which the packet is intended. Displays the destination IP address. Displays the destination IP address mask. Displays the OSPF priority Displays information available in the Options field of the HELLO packet: • N + (N-bit is set) • N - (N-bit is not set) • MC+ (bit used by MOSPF is set and router is able to forward IP multicast packets) • MC- (bit used by MOSPF is not set and router cannot forward IP multicast packets) • E + (router is able to accept AS External LSAs) • E - (router cannot accept AS External LSAs) • T + (router can support TOS) • T - (router cannot support TOS) Displays the amount of time configured for the HELLO interval. Displays the amount of time configured for the DEAD interval. Displays the IP address of the designated router. Displays the IP address of the Border Area Router. Dell#debug ip ospf 1 packet OSPF process 90, packet debugging is on Dell# 08:14:24 : OSPF(100:00): Open Shortest Path First (OSPFv2 and OSPFv3) 1491